Siemens SIMATIC NET APE1402 Manual de configuración - Página 17
Navegue en línea o descargue pdf Manual de configuración para Equipamiento industrial Siemens SIMATIC NET APE1402. Siemens SIMATIC NET APE1402 36 páginas. Application processing engine
Imprimir página
Overview
1.10.1 Example: Networking in Factory Default Conditions
Figure 1.3
In the factory default condition, all Ethernet interfaces on the RUGGEDCOM RX15xx
router (including the internal port of the RUGGEDCOM APE) are created as switched
ports in the default VLAN. When DHCP is configured in RUGGEDCOM ROX II, an IPv4
subnet and a gateway IP are automatically assigned to this VLAN.
In RUGGEDCOM ROX II, the default conditions for this VLAN are to use PVID 1 and to
operate untagged. The factory default creates the switch group (switch.0001) for de-
vices on this VLAN and creates a virtual interface 192.168.0.2/24 for devices (such as
the RUGGEDCOM APE) in switch.0001 to reach services on the control module and
network management.
In this situation, the RUGGEDCOM APE can be assigned an unused IP address in sub-
net 192.168.0.0/24 and communicate with other devices in VLAN1 at a bridging and
routing level. In
terface has been assigned an address of 192.168.0.1, either manually by the user
or automatically by a pre-configured DHCP server, to allow it to communicate on
VLAN1. It has also been assigned a unique subnet to its ETH1 port.
The RUGGEDCOM APE can also access services and network management of the
RUGGEDCOM RX1500 control module at its 192.168.0.2 address. These services in-
clude SSH, HTTP and HTTPS services for network management, DHCP, NTP and TCP
connections to chassis serial ports.
The RUGGEDCOM APE can also communicate with any hosts on interfaces lm-2-1
through lm-2-4.
Should you wish to configure the RUGGEDCOM APE to forward traffic through to the
192.168.1.0/24 network via fe-cm-1, you would need to configure 192.168.0.2 as a
default gateway.
For much the same reason, should you wish to forward traffic arriving on fe-cm-1
through to the 172.16.0.0/16 network via the RUGGEDCOM APE, you would need to
configure a route for it on the RUGGEDCOM RX15xx device and enable IP forwarding
from the Windows or Linux operating system.
Note
When operating the RUGGEDCOM APE in either switch or router mode, the RUGGED-
COM RX15xx will issue RSTP BPDUs to the RUGGEDCOM APE.
8
Example Configuration
Figure 1.3, "Example
Configuration", the RUGGEDCOM APE ETH0 in-
RUGGEDCOM APE (Application Processing Engine)
Configuration Manual, 12/2019, C79000-G8976-1121-05