Cisco 6800 Series Instalación del hardware - Página 20

Navegue en línea o descargue pdf Instalación del hardware para Teléfono IP Cisco 6800 Series. Cisco 6800 Series 20 páginas. Ip phone, multiplatform phones
También para Cisco 6800 Series: Manual de inicio rápido (3 páginas), Manual del usuario (8 páginas), Manual de mantenimiento (8 páginas), Manual del usuario (14 páginas), Manual de solución de problemas (12 páginas), Manual de inicio rápido (4 páginas), Manual del usuario (22 páginas), Manual de inicio rápido (4 páginas), Manual de instalación (39 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (2 páginas)

Charge the Handset Battery

Caution

Charge the battery with the handset charger provided. If you use another method, you can damage the battery,

the handset, or your surrounding area.

Only charge the battery in environments where the temperature is between 32°F (0°C) and 104°F (40°C).

Caution

Don't charge the battery in hazardous environments or where there's explosion danger.

When you place the handset into the charger, it turns on (if not already on) and displays a message that the

handset is charging. The handset screen dims and turns off at the configured time.

If the LED on the handset starts to flash, the handset is updating its firmware.

Before you begin

Set up the cradle as described in

Ensure that your handset charger is plugged into the electrical outlet.

Procedure

Place the handset in the charger so that the contacts in the handset and the contacts in the charger match.

The handset beeps, screen turns on, and displays a message that the handset is charging. If this doesn't happen,

remove the handset from the charger and try again.

If the handset beeps continuously while on the charger, try the troubleshooting solution available in the section

Handset Beeps Continuously While in the

Hardware Installation

Set Up the Charging Cradle, on page

Charger.

Hardware Installation

19.