Cisco 6800 Series Installazione dell'hardware - Pagina 20

Sfoglia online o scarica il pdf Installazione dell'hardware per Telefono IP Cisco 6800 Series. Cisco 6800 Series 20. Ip phone, multiplatform phones
Anche per Cisco 6800 Series: Manuale di avvio rapido (3 pagine), Manuale d'uso (8 pagine), Manuale di manutenzione (8 pagine), Manuale d'uso (14 pagine), Manuale di risoluzione dei problemi (12 pagine), Manuale di avvio rapido (4 pagine), Manuale d'uso (22 pagine), Manuale di avvio rapido (4 pagine), Manuale di installazione (39 pagine), Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (2 pagine)

Charge the Handset Battery

Caution

Charge the battery with the handset charger provided. If you use another method, you can damage the battery,

the handset, or your surrounding area.

Only charge the battery in environments where the temperature is between 32°F (0°C) and 104°F (40°C).

Caution

Don't charge the battery in hazardous environments or where there's explosion danger.

When you place the handset into the charger, it turns on (if not already on) and displays a message that the

handset is charging. The handset screen dims and turns off at the configured time.

If the LED on the handset starts to flash, the handset is updating its firmware.

Before you begin

Set up the cradle as described in

Ensure that your handset charger is plugged into the electrical outlet.

Procedure

Place the handset in the charger so that the contacts in the handset and the contacts in the charger match.

The handset beeps, screen turns on, and displays a message that the handset is charging. If this doesn't happen,

remove the handset from the charger and try again.

If the handset beeps continuously while on the charger, try the troubleshooting solution available in the section

Handset Beeps Continuously While in the

Hardware Installation

Set Up the Charging Cradle, on page

Charger.

Hardware Installation

19.