ACD DS210 Series Breve descripción - Página 12
Navegue en línea o descargue pdf Breve descripción para Dispositivos portátiles ACD DS210 Series. ACD DS210 Series 15 páginas.
También para ACD DS210 Series: Documentación de hardware (20 páginas)
Imprimir página5.2 Inserting the battery into the M210SE handheld terminal
The battery compartment is located on the rear of the device. In order to open the cover, first remove the
transverse hand strap by simply unhooking it. Now push the locking tab on the battery compartment cover
towards the cover surface. The compartment opens.
The battery can be inserted without application of force. The long groove on the unlabelled side of the
battery is the top side. The opening of the groove faces the recess for the opening mechanism. In doing so,
ensure that you insert the battery at a slight incline towards the contacts and then bring it into its final
position whilst applying a slight amount of pressure. First, place the cover on the three securing straps and
then push into the locking mechanism.
Fig. 5: Inserting the battery
5.3 Inserting the M210SE into the DS210
Figure. 6: Inserting the M210SE into the DS210
5.4 Switching on the M210SE handheld terminal
In order to switch on the device, press the "C" button and the "jump" button to the right of "0" until the LED
beneath it lights up. You can then release the buttons. The desktop of your operating system or your usual
work environment appears.
5.5 Suspend mode
In suspend mode, the operating system and the application running on it are stopped. The display is
switched off and consequently becomes dark. Suspend mode can be accessed by switching off the M210SE
(see Chapter 10). Upon leaving suspend mode (switching on the M210SE), the application and the operating
system starts to run from the same point. Thanks to both measures, the M210SE only uses an extremely
small amount of power.
5.6 Switching off the M210SE handheld terminal
As is the case when switching on, the device can be switched off by pressing both buttons next to "0",
whereby the "C" button must first be pressed and held. Then the "jump" button must also be pressed.
M210SE_Set_Kurzübersicht_V1 03_de_en.doc
12 / 15