ACD DS210 Series Brief Overview - Page 12

Browse online or download pdf Brief Overview for Handhelds ACD DS210 Series. ACD DS210 Series 15 pages.
Also for ACD DS210 Series: Hardware Documentation (20 pages)

Print Page

5.2 Inserting the battery into the M210SE handheld terminal

The battery compartment is located on the rear of the device. In order to open the cover, first remove the

transverse hand strap by simply unhooking it. Now push the locking tab on the battery compartment cover

towards the cover surface. The compartment opens.

The battery can be inserted without application of force. The long groove on the unlabelled side of the

battery is the top side. The opening of the groove faces the recess for the opening mechanism. In doing so,

ensure that you insert the battery at a slight incline towards the contacts and then bring it into its final

position whilst applying a slight amount of pressure. First, place the cover on the three securing straps and

then push into the locking mechanism.

Fig. 5: Inserting the battery

5.3 Inserting the M210SE into the DS210

Figure. 6: Inserting the M210SE into the DS210

5.4 Switching on the M210SE handheld terminal

In order to switch on the device, press the "C" button and the "jump" button to the right of "0" until the LED

beneath it lights up. You can then release the buttons. The desktop of your operating system or your usual

work environment appears.

5.5 Suspend mode

In suspend mode, the operating system and the application running on it are stopped. The display is

switched off and consequently becomes dark. Suspend mode can be accessed by switching off the M210SE

(see Chapter 10). Upon leaving suspend mode (switching on the M210SE), the application and the operating

system starts to run from the same point. Thanks to both measures, the M210SE only uses an extremely

small amount of power.

5.6 Switching off the M210SE handheld terminal

As is the case when switching on, the device can be switched off by pressing both buttons next to "0",

whereby the "C" button must first be pressed and held. Then the "jump" button must also be pressed.

M210SE_Set_Kurzübersicht_V1 03_de_en.doc

12 / 15