Siemens SITRANS LVL100 Manual de instrucciones - Página 24
Navegue en línea o descargue pdf Manual de instrucciones para Interruptor Siemens SITRANS LVL100. Siemens SITRANS LVL100 32 páginas. Vibrating switches
También para Siemens SITRANS LVL100: Manual de instrucciones (32 páginas), Manual de instrucciones (33 páginas), Manual de instrucciones (32 páginas)
Imprimir página
Electromechanical data
M12 x 1 plug connector
Ʋ Cable
Electrical protective measures
Protection rating
Ʋ M12 x 1 plug connection
Overvoltage category
Protection class
9.2
Device communication IO-Link
In the following, the necessary device-specific details are shown. You can find further information of
IO-Link on www.io-link.com.
Physical layer
IO-Link specification: Revision 1.0
SIO mode: Yes
Speed: COM2 38.4 kBaud
Min. cycle time 2.3 ms
Length process data word: 32 Bit
IO-Link Data Storage: Yes
Block parameter adjustment: Yes
Process data
The process data of the devices are transmitted cyclically in a data telegram, whereby the process
data size is defined by the device. Process data from 0 to 32 bytes are possible for each device
(both input and output). The consistency width of the transmission is not fixed and is therefore
master-dependent.
Bit 7
Bit 6
-
Q-signal (Bit 0): covered 1, uncovered 0
Device data
Device data can be parameters, identification data and diagnostic information. They are exchanged
acyclically and on request of the IO-Link master. Device data can be written to the device (write) or
read from the device (read). For this purpose, the ISDU (Indexed Service Data Unit) was defined
in the IO-Link specification. The ISDU determines, among other things, whether the data is read or
written.
24
Fixed connected to the plug
IP66/IP67 acc. to IEC 60529, Type 4X acc. to NEMA or
IP68 (0.2 bar) acc. to IEC 60529, Type 6P acc. to NEMA
The feeding power supply unit can be connected to
networks of overvoltage category III
II
Bit 5
Bit 4
-
-
SITRANS LVL100 - Operating Instructions
Bit 3
Bit 2
-
-
Bit 1
Bit 0
-
-
Q-signal