- ページ 24

スイッチ Siemens SITRANS LVL100のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Siemens SITRANS LVL100 32 ページ。 Vibrating switches
Siemens SITRANS LVL100 にも：取扱説明書 (32 ページ), 取扱説明書 (33 ページ), 取扱説明書 (32 ページ)

ページを印刷する

Electromechanical data

M12 x 1 plug connector

Ʋ Cable

Electrical protective measures

Protection rating

Ʋ M12 x 1 plug connection

Overvoltage category

Protection class

9.2

Device communication IO-Link

In the following, the necessary device-specific details are shown. You can find further information of

IO-Link on www.io-link.com.

Physical layer

IO-Link specification: Revision 1.0

SIO mode: Yes

Speed: COM2 38.4 kBaud

Min. cycle time 2.3 ms

Length process data word: 32 Bit

IO-Link Data Storage: Yes

Block parameter adjustment: Yes

Process data

The process data of the devices are transmitted cyclically in a data telegram, whereby the process

data size is defined by the device. Process data from 0 to 32 bytes are possible for each device

(both input and output). The consistency width of the transmission is not fixed and is therefore

master-dependent.

Bit 7

Bit 6

Q-signal (Bit 0): covered 1, uncovered 0

Device data

Device data can be parameters, identification data and diagnostic information. They are exchanged

acyclically and on request of the IO-Link master. Device data can be written to the device (write) or

read from the device (read). For this purpose, the ISDU (Indexed Service Data Unit) was defined

in the IO-Link specification. The ISDU determines, among other things, whether the data is read or

written.

Fixed connected to the plug

IP66/IP67 acc. to IEC 60529, Type 4X acc. to NEMA or

IP68 (0.2 bar) acc. to IEC 60529, Type 6P acc. to NEMA

The feeding power supply unit can be connected to

networks of overvoltage category III

Bit 5

Bit 4

SITRANS LVL100 - Operating Instructions

Bit 3

Bit 2

Bit 1

Bit 0

Q-signal