Cisco Cisco Access Registrar 4.2 Configuración de los ajustes de red - Página 13

Navegue en línea o descargue pdf Configuración de los ajustes de red para Teléfono IP Cisco Cisco Access Registrar 4.2. Cisco Cisco Access Registrar 4.2 34 páginas. Telepresence conference system
También para Cisco Cisco Access Registrar 4.2: Manual del usuario (44 páginas), Manual de introducción (46 páginas)

Imprimir página
Cisco Cisco Access Registrar 4.2 Configuración de los ajustes de red
Chapter 4
Configuring Network Settings on the Cisco Unified IP Phone
Modifying DHCP Settings
Enabling DHCP
Step 2
Step 3
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 4.2, Cisco Unified IP Phone
OL-8617-01
Dynamic Host Configuration Protocol (DHCP) automatically assigns IP
addresses to devices when you connect them to the network. This section provides
information about enabling DHCP and releasing a DHCP-assigned IP address in
the following topics:
Enabling DHCP, page 4-13
•
•
Disabling DHCP, page 4-15
Releasing a DHCP Address, page 4-16
•
Cisco Unified IP Phones enable DHCP by default, but you can reset the protocol
if it becomes disabled.
To enable DHCP for the Cisco Unified IP Phone, follow these steps:
For instructions, see the
In the pane on the left under Change Configuration, click Network Parameters.
To enable DHCP, enter 1 in the DHCP field and click Apply.
"Accessing Network Settings through a Phone
4-2.
Modifying DHCP Settings
4-13