Cisco Cisco Access Registrar 4.2 Konfigurowanie ustawień sieciowych - Strona 13

Przeglądaj online lub pobierz pdf Konfigurowanie ustawień sieciowych dla Telefon IP Cisco Cisco Access Registrar 4.2. Cisco Cisco Access Registrar 4.2 34 stron. Telepresence conference system
Również dla Cisco Cisco Access Registrar 4.2: Podręcznik użytkownika (44 strony), Podręcznik dla początkujących (46 strony)

Drukuj stronę
Cisco Cisco Access Registrar 4.2 Konfigurowanie ustawień sieciowych
Chapter 4
Configuring Network Settings on the Cisco Unified IP Phone
Modifying DHCP Settings
Enabling DHCP
Step 2
Step 3
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 4.2, Cisco Unified IP Phone
OL-8617-01
Dynamic Host Configuration Protocol (DHCP) automatically assigns IP
addresses to devices when you connect them to the network. This section provides
information about enabling DHCP and releasing a DHCP-assigned IP address in
the following topics:
Enabling DHCP, page 4-13
•
•
Disabling DHCP, page 4-15
Releasing a DHCP Address, page 4-16
•
Cisco Unified IP Phones enable DHCP by default, but you can reset the protocol
if it becomes disabled.
To enable DHCP for the Cisco Unified IP Phone, follow these steps:
For instructions, see the
In the pane on the left under Change Configuration, click Network Parameters.
To enable DHCP, enter 1 in the DHCP field and click Apply.
"Accessing Network Settings through a Phone
4-2.
Modifying DHCP Settings
4-13