Cisco 10000 Series Manual de instalación - Página 9
Navegue en línea o descargue pdf Manual de instalación para Enrutador de red Cisco 10000 Series. Cisco 10000 Series 14 páginas. Cisco systems router installation guide
También para Cisco 10000 Series: Boletín de productos (12 páginas)
Imprimir página
On the active ESR-PRE2 in privileged EXEC mode, enter the hw-module sec-cpu reset command to
Step 7
reboot the standby ESR-PRE2. This will load the 12.2(28)SB image from bootflash, and the standby
PRE2 will come up in RPR mode.
Note
The standby ESR-PRE2 is now in cold standby RPR state. It has not yet processed its configuration. You
can verify its redundancy mode using the show redundancy command on the active ESR-PRE2.
From the active ESR-PRE2, enter the redundancy force-switchover main-cpu command in privileged
Step 8
EXEC mode. The standby ESR-PRE2 will become the new active ESR-PRE2 (running 12.2S), and the
former active ESR-PRE2 will become the standby ESR-PRE2. Check that the system is carrying traffic.
Verify the autoboot string and IOS version using the show bootvar and show version commands.
Now you should test the 12.2(28)SB image to determine whether or not a rollback to the previous version
Note
is needed.
Step 9
When you know that rollback is not needed, enter the write memory command from the active console
to bring the startup configuration up to date on the active and standby ESR-PRE2s.
If you need to roll back, follow the procedure in the next section.
Rollback Procedure for Option 4
If the newly active ESR-PRE2 does not operate satisfactorily after
switchover to revert to the original 12.3 operating system.
To initiated a rollback switchover, follow these steps:
Copy the original startup configuration from the TFTP server to the startup configuration on the active
Step 1
and standby ESR-PRE2s using the copy tftp startup and copy tftp stby-nvram:startup-config
commands.
Use the show bootvar command to verify that this action has modified the boot variable to point to the
Step 2
old release image.
Enter the hw-module standby-cpu reset command from the active console. This command resets the
Step 3
standby ESR-PRE2, which will autoboot to the old release image and come up as the standby ESR-PRE2
in RPR mode.
Enter the redundancy force-switchover main-cpu command from the active console. This is a
Step 4
service-affecting step. The standby ESR-PRE2 will come up as the active ESR-PRE2 running the old
release. The standby ESR-PRE2 will autoboot to the old release, running in RPR+ mode.
You have now reverted to the original system configuration.
Obtaining Documentation
Cisco documentation and additional literature are available on Cisco.com. Cisco also provides several
ways to obtain technical assistance and other technical resources. These sections explain how to obtain
technical information from Cisco Systems.
OL-8833-01
Upgrading to Cisco IOS Release 12.2(28)SB on a Cisco 10000 Series Router
Obtaining Documentation
Step
8, you can initiate a rollback
9