Cisco 2811 Series Operaciones - Página 16

Navegue en línea o descargue pdf Operaciones para Enrutador de red Cisco 2811 Series. Cisco 2811 Series 31 páginas. 2800 series integrated services routers
También para Cisco 2811 Series: Ficha de datos (20 páginas), Operaciones (31 páginas), Instalación y actualización (14 páginas), Manual de inicio rápido (47 páginas)

Imprimir página

1. Clean the cover of any grease, dirt, or oil before applying the tamper evidence

labels. Alcohol-based cleaning pads are recommended for this purpose. The

temperature of the router should be above 10 C.

2. The tamper evidence label should be placed so that one half of the label covers

the front panel and the other half covers the enclosure.

3. The tamper evidence label should be placed over the CF card in the slot so that

any attempt to remove the card will show sign of tampering.

4. The tamper evidence label should be placed so that the one half of the label

covers the enclosure and the other half covers the port adapter slot.

5. The tamper evidence label should be placed so that the one half of the label

covers the enclosure and the other half covers the rear panel.

6. Place tamper evident labels on the opacity shield as shown in Figure 11.

7. The labels completely cure within five minutes.

Figures 9, 10 and 11 show the additional tamper evidence label placements for the 2811.

Figure 10 – 2811 Tamper Evident Label Placement (Front View)

This document may be freely reproduced and distributed whole and intact including this Copyright Notice.

Figure 9 – 2811 Tamper Evident Label Placement (Back View)