Cisco 2811 Series 운영 - 페이지 16

{카테고리_이름} Cisco 2811 Series에 대한 운영을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2811 Series 31 페이지. 2800 series integrated services routers
Cisco 2811 Series에 대해서도 마찬가지입니다: 데이터시트 (20 페이지), 운영 (31 페이지), 설치 및 업그레이드 (14 페이지), 빠른 시작 매뉴얼 (47 페이지)

페이지 인쇄

1. Clean the cover of any grease, dirt, or oil before applying the tamper evidence

labels. Alcohol-based cleaning pads are recommended for this purpose. The

temperature of the router should be above 10 C.

2. The tamper evidence label should be placed so that one half of the label covers

the front panel and the other half covers the enclosure.

3. The tamper evidence label should be placed over the CF card in the slot so that

any attempt to remove the card will show sign of tampering.

4. The tamper evidence label should be placed so that the one half of the label

covers the enclosure and the other half covers the port adapter slot.

5. The tamper evidence label should be placed so that the one half of the label

covers the enclosure and the other half covers the rear panel.

6. Place tamper evident labels on the opacity shield as shown in Figure 11.

7. The labels completely cure within five minutes.

Figures 9, 10 and 11 show the additional tamper evidence label placements for the 2811.

Figure 10 – 2811 Tamper Evident Label Placement (Front View)

This document may be freely reproduced and distributed whole and intact including this Copyright Notice.

Figure 9 – 2811 Tamper Evident Label Placement (Back View)