Cisco 2950 - Catalyst Switch Manual de introducción - Página 14

Navegue en línea o descargue pdf Manual de introducción para Enrutador de red Cisco 2950 - Catalyst Switch. Cisco 2950 - Catalyst Switch 29 páginas. Long-reach ethernet switches
También para Cisco 2950 - Catalyst Switch: Manual de soluciones (17 páginas), Boletín de productos (3 páginas), Boletín de asistencia sobre productos (5 páginas), Manual de migración (25 páginas), Boletín de asistencia sobre productos (6 páginas), Ficha de datos (20 páginas), Manual (19 páginas)

Connect to the Switch Ports

This section describes how to connect to the fixed switch ports and to the SFP and GBIC module ports.

Connect to 10/100 and 10/100/1000 Ports

Follow these steps:

When you connect to servers,

Step 1

workstations, IP phones, wireless

access points, and routers, insert a

straight-through, twisted four-pair,

Category 5 cable in a switch 10/100 or

10/100/1000 port. Use a crossover,

twisted four-pair, Category 5 cable

when you connect to other switches,

hubs, or repeaters.

Step 2

Insert the other cable end into an RJ-45 connector on the other device.

Connect to 100BASE-FX and 1000BASE-SX Ports

Follow these steps:

Remove the dust plugs from the

Step 1

100BASE-FX or 1000BASE-SX port

and the rubber caps from the MT-RJ

patch cable. Store them for future use.

Insert an appropriate cable into a 100BASE-FX or 1000BASE-SX port. Insert the

Step 2

other cable end into an SC or ST port on the other device.

SY ST

R PS

ST AT

U TI L

D U PL X

SP EE D

M O D E

10/100 or 10/100/1000 ports

100BASE-FX or 1000BASE-SX ports

15 X

16 X

C a ta ly s t 2

9 5 0

SE RI ES

1 0 0 B a s e

-F X

15 X

2 5

2 6

16 X