Cisco SG 300-10P Manual de inicio rápido - Página 4

Navegue en línea o descargue pdf Manual de inicio rápido para Enrutador de red Cisco SG 300-10P. Cisco SG 300-10P 18 páginas. Managed switches
También para Cisco SG 300-10P: Manual de inicio rápido (17 páginas), Ficha de datos (14 páginas), Especificaciones (2 páginas), Manual de configuración rápida (10 páginas), Manual de inicio rápido (17 páginas), Manual de inicio rápido (17 páginas)

Rack-Mount Placement

Remove the four screws from each side near the front of the switch.

TEP

Retain the screws for re-installation. (Do not remove the four screws

from each side near the back of the switch.)

Place one of the supplied spacers on the side of the switch so the

TEP

four holes of the spacers align to the screw holes. Place a rack

mount bracket next to the spacer and reinstall the four screws

removed in

If your screws are not long enough to reattach the bracket

OTE

with the spacer in place, attach the bracket directly to the case

without the spacer.

Repeat

TEP

After the mounting hardware has been securely attached, the

TEP

switch is now ready to be installed into a standard 19-inch rack.

For stability, load the rack from the bottom to the top, with the

AUTION

heaviest devices on the bottom. A top-heavy rack is likely to

be unstable and may tip over.

Only the 8-port models of the switch can be wall-mounted.

The switch should be mounted so that the ports face up or down.

OTE

Do not mount the switch with the ports to the side.

Step

Step 2

for the other side of the switch.

Cisco 300 Series Managed Switches