Cisco SG 300-10P Manuale di avvio rapido - Pagina 4
Sfoglia online o scarica il pdf Manuale di avvio rapido per Router di rete Cisco SG 300-10P. Cisco SG 300-10P 18. Managed switches
Anche per Cisco SG 300-10P: Manuale di avvio rapido (17 pagine), Scheda tecnica (14 pagine), Specifiche tecniche (2 pagine), Manuale di configurazione rapida (10 pagine), Manuale di avvio rapido (17 pagine), Manuale di avvio rapido (17 pagine)
Stampa la pagina
- 1. Quick Start Guide
- 2. Mounting the Cisco Switch
- 3. Rack-Mount Placement
- 4. Wall Mounting
- 5. Connecting Network Devices
- 6. Power over Ethernet (Poe) Considerations
- 7. Troubleshoot Your Connection
- 8. Front Panel Ports
- 9. Reset Button
- 10. Back Panel
- 11. Front Panel Leds
- 12. Returning the Device to the Factory Default Settings
- 13. Where to Go from here
Rack-Mount Placement
Remove the four screws from each side near the front of the switch.
S
1
TEP
Retain the screws for re-installation. (Do not remove the four screws
from each side near the back of the switch.)
Place one of the supplied spacers on the side of the switch so the
S
2
TEP
four holes of the spacers align to the screw holes. Place a rack
mount bracket next to the spacer and reinstall the four screws
removed in
If your screws are not long enough to reattach the bracket
N
OTE
with the spacer in place, attach the bracket directly to the case
without the spacer.
Repeat
S
3
TEP
After the mounting hardware has been securely attached, the
S
4
TEP
switch is now ready to be installed into a standard 19-inch rack.
For stability, load the rack from the bottom to the top, with the
C
AUTION
heaviest devices on the bottom. A top-heavy rack is likely to
be unstable and may tip over.
Wall Mounting
Only the 8-port models of the switch can be wall-mounted.
The switch should be mounted so that the ports face up or down.
N
OTE
Do not mount the switch with the ports to the side.
4
Step
1.
Step 2
for the other side of the switch.
Cisco 300 Series Managed Switches