Cisco Aironet 1530 Manual de introducción - Página 13

Navegue en línea o descargue pdf Manual de introducción para Punto de acceso inalámbrico Cisco Aironet 1530. Cisco Aironet 1530 41 páginas. Outdoor access points

Imprimir página

AP 1532E

The 1532E is equipped with two N-type radio frequency (RF) connectors (antenna ports 1 and 2) on

the bottom of the unit for external antennas to support multiple input multiple output (MIMO)

operation in dual-band mode, as shown in

external antennas attached. When using the Cisco Aironet AIR-ANT2547V-N Dual-Band

Omnidirectional Antenna, the 2.4- and 5-GHz antennas connect directly to the access point, as shown

Figure

7. If the antennas are remotely located, an appropriate low-loss RF coax cable should be

used.

The 1532E access point are equipped with 4 N-type radio frequency (RF) connectors (antenna ports

1 and 2 on the bottom of the unit for 2-GHz and antenna ports 3 and 4 on the top of the unit for

5-GHz) for external antennas to support multiple input multiple output (MIMO) operation. The

antenna ports located of top of the 1532E are shown in

with the appropriate external antennas attached. Ports 1 and 2 can be used for Dual Band operation

with a software configuration.

The antenna port caps must be removed for a uni-band antenna installation, but ports 3 and

Note

4 should remain capped for a dual-band antenna instlalation to provide an IP67 seal.

Figure 6

Access Point Bottom External Antenna Connectors - AP 1532E

N-Type Connector - Antenna port 1 (Tx/Rx)

Figure

6. The 1532E must always be operated with the two

Figure

3. The 1532E must always be operated

N-Type Connector - Antenna port 2(Tx/Rx)