Cisco Aironet 1530 Manual de iniciação - Página 13

Procurar online ou descarregar pdf Manual de iniciação para Ponto de acesso sem fios Cisco Aironet 1530. Cisco Aironet 1530 41 páginas. Outdoor access points

Imprimir página
AP 1532E
The 1532E is equipped with two N-type radio frequency (RF) connectors (antenna ports 1 and 2) on
the bottom of the unit for external antennas to support multiple input multiple output (MIMO)
operation in dual-band mode, as shown in
external antennas attached. When using the Cisco Aironet AIR-ANT2547V-N Dual-Band
Omnidirectional Antenna, the 2.4- and 5-GHz antennas connect directly to the access point, as shown
in
Figure
7. If the antennas are remotely located, an appropriate low-loss RF coax cable should be
used.
The 1532E access point are equipped with 4 N-type radio frequency (RF) connectors (antenna ports
1 and 2 on the bottom of the unit for 2-GHz and antenna ports 3 and 4 on the top of the unit for
5-GHz) for external antennas to support multiple input multiple output (MIMO) operation. The
antenna ports located of top of the 1532E are shown in
with the appropriate external antennas attached. Ports 1 and 2 can be used for Dual Band operation
with a software configuration.
The antenna port caps must be removed for a uni-band antenna installation, but ports 3 and
Note
4 should remain capped for a dual-band antenna instlalation to provide an IP67 seal.
Figure 6
Access Point Bottom External Antenna Connectors - AP 1532E
1
N-Type Connector - Antenna port 1 (Tx/Rx)
1
Figure
6. The 1532E must always be operated with the two
Figure
3. The 1532E must always be operated
N-Type Connector - Antenna port 2(Tx/Rx)
2
2
13