Cisco WAP371 Manual de inicio rápido - Página 5

Navegue en línea o descargue pdf Manual de inicio rápido para Punto de acceso inalámbrico Cisco WAP371. Cisco WAP371 38 páginas. Reboot and reset to factory default settings
También para Cisco WAP371: Manual de inicio rápido (15 páginas), Manual (5 páginas), Manual (4 páginas)

Imprimir página

To mount the Cisco WAP 371 device to a wall or ceiling:

Determine where you want to mount the device. Verify that the surface is

TEP

smooth, flat, dry, and sturdy.

Drill two pilot holes into the surface 2.75 inches (70 mm) apart for your

TEP

Cisco WAP device.

Insert a screw into each hole, leaving a gap between the surface and the base

TEP

of the screw head.

Place the upper slots of the bracket over the screws, adjust the screws

TEP

accordingly, and slide the bracket down until the screws fit snugly into the

slots.

Using the bracket as a template, drill two more holes for the lower screws.

TEP

Insert a screw into each lower hole.

TEP

Slide the WAP device into the bracket, placing the cable through the break-

TEP

out tab found in the back of the bracket.

Connecting the Cisco WAP371 Wireless-AC/N

Dual Radio Access Point with Single Point Setup

The default configuration of the device has the Wi-Fi radio turned off. You must

perform the initial configuration using a wired Ethernet connection. To connect the

device to the wired network:

Connect the Ethernet cable to the Ethernet port of a switch, a router, or a PC.

TEP

Connect the other end of the network Ethernet cable to the Ethernet port of

TEP

the wireless access point.

After installation, all lights should be active. Refer to

Installation, page 6

Cisco Small Business WAP371 Series Wireless Access Point

for details about the different lights on each switch.

Verifying the Hardware