Cisco WAP371 Краткое руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Беспроводная точка доступа Cisco WAP371. Cisco WAP371 38 страниц. Reboot and reset to factory default settings
Также для Cisco WAP371: Краткое руководство по эксплуатации (15 страниц), Руководство (5 страниц), Руководство (4 страниц)
Печатать страницу
To mount the Cisco WAP 371 device to a wall or ceiling:
Determine where you want to mount the device. Verify that the surface is
S
1
TEP
smooth, flat, dry, and sturdy.
Drill two pilot holes into the surface 2.75 inches (70 mm) apart for your
S
2
TEP
Cisco WAP device.
Insert a screw into each hole, leaving a gap between the surface and the base
S
3
TEP
of the screw head.
Place the upper slots of the bracket over the screws, adjust the screws
S
4
TEP
accordingly, and slide the bracket down until the screws fit snugly into the
slots.
Using the bracket as a template, drill two more holes for the lower screws.
S
5
TEP
Insert a screw into each lower hole.
S
6
TEP
Slide the WAP device into the bracket, placing the cable through the break-
S
7
TEP
out tab found in the back of the bracket.
Connecting the Cisco WAP371 Wireless-AC/N
4
Dual Radio Access Point with Single Point Setup
The default configuration of the device has the Wi-Fi radio turned off. You must
perform the initial configuration using a wired Ethernet connection. To connect the
device to the wired network:
Connect the Ethernet cable to the Ethernet port of a switch, a router, or a PC.
S
1
TEP
Connect the other end of the network Ethernet cable to the Ethernet port of
S
2
TEP
the wireless access point.
After installation, all lights should be active. Refer to
Installation, page 6
Cisco Small Business WAP371 Series Wireless Access Point
for details about the different lights on each switch.
Verifying the Hardware
5