Argo DD DCI Manual de instrucciones de instalación - Página 13
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Aire acondicionado Argo DD DCI. Argo DD DCI 16 páginas. Air conditioner without outdoor unit
Imprimir página
During the heating mode, the air conditioner will now operate with the new calibration of the air probe.
Nota: this setting has no effect when I Feel is selected. In this case the air conditioner will operate with the remote
control air probe.
ATM mode setting
It is possible to set the air conditioner to operate automatically without a remote control so that it maintains the room
temperature between 18°C and 24°C. A typical application is that of installation within ATMs (cash machine) of banks. In
this mode it is not necessary to set the desired temperature or operating mode, but it will all be managed automatically
by the air conditioner.
To activate this mode, follow the procedure below:
1. Press and hold the "FILTER" button (symbol) for more than 7 seconds. A number will appear on the remote control
screen.
2. Press the + or - keys until the number 11 is displayed.
3. Hold down the "FILTER" button for more than 7 seconds and release it by pointing the remote control at the air
conditioning receiver. An acoustic confirmation of 4 consecutive "beeps" will confirm the successful setting.
Nota: 60 seconds after activating ATM mode the remote control is disabled.
To disable ATM mode, follow the procedure below:
1. Disconnect the power of the air conditioner
2. Wait for 1 minute
3. Re-connect power to the air conditioner
4. Within 60 seconds (before the remote control is disabled again), repeat the procedure above. An acoustic confirmation
of 2 consecutive "beeps" will confirm that the original setting has been reset.
Display setting : Celsius degrees / Fahrenheit degrees
The remote control is set by default to display the temperature expressed in Celsius degrees.
To change the temperature display from Celsius degrees to Fahrenheit degrees (and vice versa), follow the procedure
below:
1. Hold down the "FILTER" button for more than 7 seconds and release it. A number will appear on the remote control
screen.
2. Press the + or - keys until the number 77 is displayed.
3. Hold down the "FILTER" button for more than 7 seconds and release it. The temperature will now be displayed on
the remote control screen with the new setting.
Note: if you remove the batteries from the remote control, the default display is reset.
Factory settings' reset
To reset the factory settings, follow the procedure below:
1. Hold down the "FILTER" button for more than 7 seconds and release it. A number will appear on the remote control
screen.
2. Press the + or - keys until the number 0 is displayed.
3. Hold down the "FILTER" button for more than 7 seconds and release it by pointing the remote control at the air
conditioning receiver. An acoustic confirmation of 2 consecutive "beeps" will confirm the correct reset of the factory
settings.
Note: to reset the temperature display in Celsius degrees, remove and replace the batteries of the remote control unit.
13
EN