Cisco TelePresence SX20 Manual de introducción - Página 29

Navegue en línea o descargue pdf Manual de introducción para Sistema de conferencias Cisco TelePresence SX20. Cisco TelePresence SX20 46 páginas. In-room control on touch 10
También para Cisco TelePresence SX20: Juego rápido (8 páginas), Manual de introducción (41 páginas), Manual de introducción (42 páginas), Manual de consulta rápida (2 páginas), Juego rápido (2 páginas), Manual de consulta rápida (2 páginas), Manual del usuario (34 páginas), Manual del usuario (29 páginas), Manual de solución de problemas (37 páginas), Manual de cumplimiento de la normativa e información de seguridad (9 páginas), Manual de instalación (8 páginas), Manual del usuario (38 páginas), Manual de instalación (2 páginas), Manual del usuario (2 páginas), Manual de consulta rápida (2 páginas), Manual del usuario (37 páginas), Manual (45 páginas), Manual (45 páginas), Hoja de instalación (2 páginas), Manual de instalación (2 páginas), Manual del usuario (34 páginas), Manual del usuario (5 páginas), Manual del usuario (38 páginas), Manual del usuario (38 páginas), Manual de introducción (42 páginas), Manual de referencia (8 páginas)

Imprimir página

Cisco TelePresence SX20 Manual de introducción

Cisco TelePresence Video Systems

Contents

Setup assistant for SX10

When you start the system for the first time, the Setup assistant

starts automatically.

On first time setup, you will be prompted for a software upgrade.

We recommend that you wait for the software upgrade message

and upgrade before you continue on the setup assistant.

•

If you do decide to upgrade mid setup, changes to the

settings will not persist.

•

If you choose to postpone the software upgrade, you will

be prompted again in six hours.

If your system is automatically provisioned, the IP and provision-

ing settings are automatically configured. To keep the automatic

settings, skip these stages on the Setup assistant.

Start the Setup assistant

Navigate to the upper left corner on the home screen and press

on the remote control.

Navigate to

Settings

and press OK. Navigate to

and press OK. Follow the instructions on screen.

If the system does not show a menu on screen:

•

Make sure the monitor is connected and has been switched

on.

•

Make sure that the correct input is selected on the monitor.

•

Make sure the remote control has batteries installed.

•

Make sure the system is switched on.

If the system has just been switched on, wait a few minutes to

allow the system to start up.

If there is still no menu on screen, make sure the monitor cable

is connected to the video output connector. If in doubt, see the

installation guide for your product.

Back to task overview

D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.

Introduction

User interfaces

Setup assistant

Configuration

On-screen display

Getting Started Guide

Appendices

Contacts