Cisco 3020 - Cisco Catalyst Blade Switch Nota de publicación

Navegue en línea o descargue pdf Nota de publicación para Hardware de red Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 41 páginas. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
También para Cisco 3020 - Cisco Catalyst Blade Switch: Manual de introducción (37 páginas), Manual de introducción (31 páginas), Quickspecs (12 páginas), Nota de publicación (27 páginas), Nota de publicación (23 páginas), Nota de publicación (21 páginas), Manual de instalación (21 páginas)

Imprimir página

Cisco 3020 - Cisco Catalyst Blade Switch Nota de publicación

Release Notes for the Cisco Catalyst

Blade Switch 3020 for HP,

Cisco IOS Release 12.2(35)SE and Later

Revised May 22, 2007

Cisco IOS Release 12.2(35)SE and later runs on the Cisco Catalyst Blade Switch 3020 for HP, also

referred to as the switch.

These release notes include important information about Cisco IOS Release 12.2(35)SE and later and

any limitations, restrictions, and caveats that apply to them. Verify that these release notes are correct

for your switch:

•

For the complete list of Cisco Catalyst Blade Switch 3020 for HP documentation, see the

Documentation" section on page

You can download the switch software from this site (registered Cisco.com users with a login password):

http://www.cisco.com/kobayashi/sw-center/sw-lan.shtml

This software release is part of a special release of Cisco IOS software that is not released on the same

8-week maintenance cycle that is used for other platforms. As maintenance releases and future software

releases become available, they will be posted to Cisco.com in the Cisco IOS software area.

Contents

This information is in the release notes:

•

Corporate Headquarters:

Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA

If you are installing a new switch, see the Cisco IOS release label on the rear panel of your switch.

If your switch is on, use the show version privileged EXEC command. See the

Software Version and Feature Set" section on page

If you are upgrading to a new release, see the software upgrade filename for the software version.

See the

"Deciding Which Files to Use" section on page

"System Requirements" section on page 2

"Upgrading the Switch Software" section on page 3

"Installation Notes" section on page 6

33.

"Finding the

"Related