Cisco 3020 - Cisco Catalyst Blade Switch Примітка до випуску

Переглянути онлайн або завантажити pdf Примітка до випуску для Мережеве обладнання Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 41 сторінка. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Також для Cisco 3020 - Cisco Catalyst Blade Switch: Посібник для початківців (37 сторінок), Посібник для початківців (31 сторінок), Quickspecs (12 сторінок), Примітка до випуску (27 сторінок), Примітка до випуску (23 сторінок), Примітка до випуску (21 сторінок), Посібник з монтажу (21 сторінок)

Cisco 3020 - Cisco Catalyst Blade Switch Примітка до випуску
Release Notes for the Cisco Catalyst
Blade Switch 3020 for HP,
Cisco IOS Release 12.2(35)SE and Later
Revised May 22, 2007
Cisco IOS Release 12.2(35)SE and later runs on the Cisco Catalyst Blade Switch 3020 for HP, also
referred to as the switch.
These release notes include important information about Cisco IOS Release 12.2(35)SE and later and
any limitations, restrictions, and caveats that apply to them. Verify that these release notes are correct
for your switch:
For the complete list of Cisco Catalyst Blade Switch 3020 for HP documentation, see the
Documentation" section on page
You can download the switch software from this site (registered Cisco.com users with a login password):
http://www.cisco.com/kobayashi/sw-center/sw-lan.shtml
This software release is part of a special release of Cisco IOS software that is not released on the same
8-week maintenance cycle that is used for other platforms. As maintenance releases and future software
releases become available, they will be posted to Cisco.com in the Cisco IOS software area.
Contents
This information is in the release notes:
Corporate Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
© 2007 Cisco Systems, Inc. All rights reserved.
If you are installing a new switch, see the Cisco IOS release label on the rear panel of your switch.
If your switch is on, use the show version privileged EXEC command. See the
Software Version and Feature Set" section on page
If you are upgrading to a new release, see the software upgrade filename for the software version.
See the
"Deciding Which Files to Use" section on page
"System Requirements" section on page 2
"Upgrading the Switch Software" section on page 3
"Installation Notes" section on page 6
3.
33.
"Finding the
3.
"Related