Argo HI FLOOR RAY Manual de instrucciones - Página 8
Navegue en línea o descargue pdf Manual de instrucciones para Calentador Argo HI FLOOR RAY. Argo HI FLOOR RAY 9 páginas. Micathermic panel heater
Imprimir página
(220-240V/50Hz).
Turn the side dial of the thermostat to the maximum (max. temperature).
Now choose the power level desired by using the switches as appropriate:
If both switches are in the '0' position, i.e. off, the panel is off.
By turning the switches to 'I' or 'II' or 'III', the panel turns on and operates at 'minimum' or 'medium' or 'maximum'
level. The red switch in the on position, lights up.
.
By setting the left-hand switch to
the 'I' position and leaving the
right-hand switch set to '0', minimum
power is selected: 500 W
Room temperature can be regulated by rotating the thermostat clockwise to increase or anticlockwise to
decrease temperature.
When turning the panel on, we recommend turning the thermostat dial to maximum: then, when a pleasant room
temperature has been obtained, turn the thermostat dial anticlockwise until the light of the active switch goes out. This
way the panel will maintain that room temperature constant.
In the event of overheating, the panel protection system automatically disables the heating elements, turning the
appliance off.
To understand whether it has turned off due to intervention by this system, rotate the thermostat switch to maximum to
verify that the thermostat has not simply turned the convector off due to having reached the set temperature.
Should the appliance not return to normal operation due to the safety device having intervened:
1. turn the panel off;
2. remove any cause of overheating (e.g. obstacles on the air outlet or intake grille, dust deposits in the appliance, etc.
3. leave the appliance to cool for 15 – 20 minutes;
4. turn the panel on again.
Always unplug and leave the panel to cool before cleaning.
Use a damp cloth to clean the panel exterior and remove dust. Leave the casing to dry before using the appliance
again.
Do not allow water to enter the panel.
Do not use benzene, solvents or abrasive compounds to clean the panel, as these may damage the casing.
Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.
Ensure that the panel is dry before inserting the plug.
Do not use metal tools to clean the panel. Any metal fragments that may detach may come into contact with the
panel's electrical components and cause a short-circuit.
In the event of malfunctions or damages, always contact an authorised service centre.
V 09/16
By setting both switches to
the 'III' position, maximum
power is selected: 1500 W
OVERHEATING SAFETY DEVICE
CLEANING THE PANEL HEATER
By setting the right-hand switch to
the 'II' position and leaving the left-
hand switch set to '0', medium power
is selected: 1000 W
);
17