- ページ 8

ヒーター Argo HI FLOOR RAYのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Argo HI FLOOR RAY 9 ページ。 Micathermic panel heater

(220-240V/50Hz).

Turn the side dial of the thermostat to the maximum (max. temperature).

Now choose the power level desired by using the switches as appropriate:

 If both switches are in the '0' position, i.e. off, the panel is off.

 By turning the switches to 'I' or 'II' or 'III', the panel turns on and operates at 'minimum' or 'medium' or 'maximum'

level. The red switch in the on position, lights up.

By setting the left-hand switch to

the 'I' position and leaving the

right-hand switch set to '0', minimum

power is selected: 500 W

Room temperature can be regulated by rotating the thermostat clockwise to increase or anticlockwise to

decrease temperature.

When turning the panel on, we recommend turning the thermostat dial to maximum: then, when a pleasant room

temperature has been obtained, turn the thermostat dial anticlockwise until the light of the active switch goes out. This

way the panel will maintain that room temperature constant.

In the event of overheating, the panel protection system automatically disables the heating elements, turning the

appliance off.

To understand whether it has turned off due to intervention by this system, rotate the thermostat switch to maximum to

verify that the thermostat has not simply turned the convector off due to having reached the set temperature.

Should the appliance not return to normal operation due to the safety device having intervened:

1. turn the panel off;

2. remove any cause of overheating (e.g. obstacles on the air outlet or intake grille, dust deposits in the appliance, etc.

3. leave the appliance to cool for 15 – 20 minutes;

4. turn the panel on again.

Always unplug and leave the panel to cool before cleaning.



Use a damp cloth to clean the panel exterior and remove dust. Leave the casing to dry before using the appliance

again.

Do not allow water to enter the panel.



Do not use benzene, solvents or abrasive compounds to clean the panel, as these may damage the casing.



Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.



Ensure that the panel is dry before inserting the plug.



Do not use metal tools to clean the panel. Any metal fragments that may detach may come into contact with the

panel's electrical components and cause a short-circuit.

In the event of malfunctions or damages, always contact an authorised service centre.



V 09/16

By setting both switches to

the 'III' position, maximum

power is selected: 1500 W

OVERHEATING SAFETY DEVICE

CLEANING THE PANEL HEATER

By setting the right-hand switch to

the 'II' position and leaving the left-

hand switch set to '0', medium power

is selected: 1000 W

);