Cisco ASA 5506W-X Manual de configuración - Página 13

Navegue en línea o descargue pdf Manual de configuración para Hardware de red Cisco ASA 5506W-X. Cisco ASA 5506W-X 13 páginas. Threat defense reimage guide
También para Cisco ASA 5506W-X: Manual de inicio rápido (10 páginas), Manual de inicio rápido (14 páginas), Manual de instalación sencilla (11 páginas), Manual de software (37 páginas), Montar y conectar (12 páginas), Manual de instalación (46 páginas), Montar el chasis (10 páginas)

ip default-gateway 10.1.0.1

interface Dot11Radio0

no shut

interface Dot11Radio1

At this point, the management configuration of the ASA and AP must be complete, and the

no shut

ASA acts as a DHCP server for VLANs 5 and 30. After saving the configuration using the write

memory command on the AP, if you still have connectivity issues then you must reload the AP

using the reload command from the CLI. However, if you receive an IP address on the newly

created SSIDs then no further action is required.

Building configuration...

[OK]

ap#reload

Proceed with reload? [confirm]

Writing out the event log to flash:/event.log ...

Note: You do NOT need to reload the entire ASA device. You must only reload the built-in

access point.

Once the AP finishes reloading, then you must have connectivity to the AP GUI from a client

machine on the wifi or inside networks. It generally takes about two minutes for the AP to

completely reboot. From this point on, you can apply the normal steps to complete the

configuration of the WAP.

Cisco ASA 5506-X Series Quick Start Guide

http://www.cisco.com/c/en/us/td/docs/security/asa/quick_start/5506X/5506x-quick-start.html#pgfId-

138410

Troubleshoot

Troubleshooting ASA connectivity is outside the scope of this document since this is intended for

initial configuration. Please refer to the verify and configuration sections to ensure that all steps

have been properly completed.

ap#write memory