Cisco ASA 5506W-X 구성 매뉴얼 - 페이지 13

{카테고리_이름} Cisco ASA 5506W-X에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5506W-X 13 페이지. Threat defense reimage guide
Cisco ASA 5506W-X에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (14 페이지), 간편한 설정 매뉴얼 (11 페이지), 소프트웨어 설명서 (37 페이지), 마운트 및 연결 (12 페이지), 설치 매뉴얼 (46 페이지), 섀시 마운트 (10 페이지)

페이지 인쇄
Cisco ASA 5506W-X 구성 매뉴얼
ip default-gateway 10.1.0.1
!
interface Dot11Radio0
no shut
!
interface Dot11Radio1
At this point, the management configuration of the ASA and AP must be complete, and the
no shut
ASA acts as a DHCP server for VLANs 5 and 30. After saving the configuration using the write
memory command on the AP, if you still have connectivity issues then you must reload the AP
using the reload command from the CLI. However, if you receive an IP address on the newly
created SSIDs then no further action is required.
Building configuration...
[OK]
ap#reload
Proceed with reload? [confirm]
Writing out the event log to flash:/event.log ...
Note: You do NOT need to reload the entire ASA device. You must only reload the built-in
access point.
Once the AP finishes reloading, then you must have connectivity to the AP GUI from a client
machine on the wifi or inside networks. It generally takes about two minutes for the AP to
completely reboot. From this point on, you can apply the normal steps to complete the
configuration of the WAP.
Cisco ASA 5506-X Series Quick Start Guide
http://www.cisco.com/c/en/us/td/docs/security/asa/quick_start/5506X/5506x-quick-start.html#pgfId-
138410

Troubleshoot

Troubleshooting ASA connectivity is outside the scope of this document since this is intended for
initial configuration. Please refer to the verify and configuration sections to ensure that all steps
have been properly completed.
ap#write memory