Cisco ASA 5585-X Manual de mantenimiento
Navegue en línea o descargue pdf Manual de mantenimiento para Hardware de red Cisco ASA 5585-X. Cisco ASA 5585-X 44 páginas. Maintenance and upgrade procedures
También para Cisco ASA 5585-X: Manual de inicio rápido (40 páginas), Manual de inicio rápido (6 páginas)
Imprimir página
Maintenance and Upgrade Procedures
This chapter describes maintenance and upgrade procedures, and includes the following sections:
•
•
•
•
•
•
•
•
•
•
Removing and Installing SSPs
The ASA 5585-X comes with a core Security Services Processor (SSP) already installed (SSP-10,
SSP-20, SSP-40, or SSP-60). You can install an additional SSP (core SSP, IPS SSP, ASA CX SSP, or
FirePOWER SSP) in slot 1.
For a matrix describing which module configurations are allowed, see the
table.
Feature limitations may apply to dual SSPs. Refer to your configuration guide for more information.
Note
The add-on SSP will not run without the core SSP installed. The add-on SSP must be installed in the
upper slot (slot 1), with the core SSP in the bottom slot (slot 0). You must power off the ASA 5585-X to
remove and install SSPs; the SSPs are not hot-swappable.
OL-22567-02
Removing and Installing SSPs, page 4-1
Removing and Installing SSP Hard Disk Drives, page 4-4
Installing and Removing Cisco ASA 5585-X Network I/O Modules, page 4-5
Removing and Installing the Power Supply Module, page 4-11
Removing and Installing the Fan Module, page 4-27
Installing a Slide Rail Kit, page 4-29
Installing and Removing a Slide-mounted Chassis, page 4-30
Mounting the Chassis Using a Fixed Rack Mount, page 4-39
Installing the Cable Management Brackets, page 4-41
Troubleshooting Loose Connections, page 4-43
C H A P T E R
Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide
4
ASA Module Compatibility
4-1