Cisco ASA 5585-X Panduan Pemeliharaan

Jelajahi secara online atau unduh pdf Panduan Pemeliharaan untuk Perangkat Keras Jaringan Cisco ASA 5585-X. Cisco ASA 5585-X 44 halaman. Maintenance and upgrade procedures
Juga untuk Cisco ASA 5585-X: Panduan Memulai Cepat (40 halaman), Panduan Memulai Cepat (6 halaman)

Halaman Cetak

Maintenance and Upgrade Procedures

This chapter describes maintenance and upgrade procedures, and includes the following sections:

•

Removing and Installing SSPs

The ASA 5585-X comes with a core Security Services Processor (SSP) already installed (SSP-10,

SSP-20, SSP-40, or SSP-60). You can install an additional SSP (core SSP, IPS SSP, ASA CX SSP, or

FirePOWER SSP) in slot 1.

For a matrix describing which module configurations are allowed, see the

table.

Feature limitations may apply to dual SSPs. Refer to your configuration guide for more information.

Note

The add-on SSP will not run without the core SSP installed. The add-on SSP must be installed in the

upper slot (slot 1), with the core SSP in the bottom slot (slot 0). You must power off the ASA 5585-X to

remove and install SSPs; the SSPs are not hot-swappable.

OL-22567-02

Removing and Installing SSPs, page 4-1

Removing and Installing SSP Hard Disk Drives, page 4-4

Installing and Removing Cisco ASA 5585-X Network I/O Modules, page 4-5

Removing and Installing the Power Supply Module, page 4-11

Removing and Installing the Fan Module, page 4-27

Installing a Slide Rail Kit, page 4-29

Installing and Removing a Slide-mounted Chassis, page 4-30

Mounting the Chassis Using a Fixed Rack Mount, page 4-39

Installing the Cable Management Brackets, page 4-41

Troubleshooting Loose Connections, page 4-43

C H A P T E R

Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide

ASA Module Compatibility

4-1