ACU-RITE SENC 150 Manual de instalación - Página 6
Navegue en línea o descargue pdf Manual de instalación para Media Converter ACU-RITE SENC 150. ACU-RITE SENC 150 6 páginas. Chevalier fsg-2a 1224 surface grinder cross feed “x” axis
También para ACU-RITE SENC 150: Manual de instalación (8 páginas), Manual de referencia (20 páginas), Manual de instalación (4 páginas), Manual de instrucciones (12 páginas)
Imprimir páginaSENC 150
Reading head installation...
Reading head
mounting holes (2)
•
Adjust the bracket so that the reading head
mounting holes align with the reading head casting.
Secure the bracket in place.
*8-32 x 3/4" SHCS (2)
A gap will exist between
bracket and reading head.
•
Insert the two *8-32 x 5/8" SHCS. Insure the bracket
is adjusted to provide proper screw head clearance.
Do Not Tighten Screws at this time.
•
Set each leveling set screw by placing a .001" - .003"
feeler gage between the set screw and the bracket.
•
Adjust each set screw until a slight drag is felt on the
feeler gage.
•
Evenly tighten the two 8-32 SHCS.
P.N. 385072-214 Ed C 11/05
Leveling set screws (3)
Installation Manual 385072-41
Encoder Installation Manual For: Bpt. Vert. Knee Milll
Cross Feed Y Axis - Right hand side
Alignment bracket removal ...
Slide brackets back
away from the
reading head and
cable
•
Use allen wrench from set screw adjustment to slide
alignment brackets away from the reading head.
•
Remove alignment brackets and save for possible
future use.
•
Move the axis through its full travel. Confirm that
the assembly does not interfere with the machine
movement.
•
With the longitudinal axis installation complete,
route the cables providing sufficient slack loops for
machine movement to the readout.
•
Secure cables by fastening with clips or ties.
•
Attach the linear encoder connectors to the readout.
•
Complete the installation by following the steps in
"Checking Your Installation" section in the encoder
"Reference Manual".
3
Twist brackets
45° to remove
Acu-Rite Companies Inc.