Digitrax PR3 XtRa Manual de inicio rápido - Página 4
Navegue en línea o descargue pdf Manual de inicio rápido para Media Converter Digitrax PR3 XtRa. Digitrax PR3 XtRa 8 páginas. Decoder programmer. usb programmer/interface
Imprimir página
Driver installations instructions
Before the PR3 Xtra can be used, drivers for your specific Windows version
must be installed. Drivers and Windows version specific instructions are avail-
able from the Digitrax website PR3 Xtra Product page:
http://www.digitrax.com/PR3Xtra
NOTE: Drivers must be installed for the PR3 Xtra to operate.
PR3 Xtra Switch Functions
The Mode Switch:
The Mode Switch next to the Green "USB" LED is used to toggle back and
forth between MS100 mode and PR3 Xtra Programmer Mode. This Green LED
will wink once per second in MS100 Mode or toggle every second in PR3 Xtra
Stand Alone programming mode. If this LED is unlit there is no USB link estal-
ished.
The LocoNet Termination Switch:
A LocoNet network always requires a termination of some sort, typically from
the Command Station. The LocoNet Termination switch next to the "ERR"
LED is designed to toggle the PR3 Xtra between a LocoNet terminated by a
Digitrax Command Station and a stand alone LocoNet where separate termina-
tion is required. The PR3 Xtra has the ability to act as a LocoNet terminator.
Set this switch active ONLY when a Command Station is NOT connected to the
LocoNet and the red LED is solid on indicating there is no Command Station
connected.
NOTE: Do not turn on the LocoNet termination mode AND connect to a
command station at the same time.
To turn on the LocoNet termination mode, press and hold this switch for at
least 2 seconds then release. The red "error" LED should go off indicating the
LocoNet termination mode is working. If the Red LED is blinking, then the
PR3 Xtra DC power in the rear 2.1mm jack is not connected or is too low.
To exit the LocoNet termination mode, press and hold this switch for 2 seconds
and then release.
Factory Default Setting:
Pressing and holding both switches for 5 seconds or longer will reset the PR3
Xtra to its original factory settings (MS100 mode with LocoNet termination
off) The "STAT" LED will toggle between red and green a few times to indi-
cate that the default settings were taken.
Refer to the table on the follow page for an explanation of LED status indicator
meanings.
©2013 Digitrax, Inc.
Complete Train Control
Run Your Trains, Not Your Track!
www.digitrax.com
4