Digitrax PR3 XtRa Manual de inicio rápido - Página 6
Navegue en línea o descargue pdf Manual de inicio rápido para Media Converter Digitrax PR3 XtRa. Digitrax PR3 XtRa 8 páginas. Decoder programmer. usb programmer/interface
Imprimir página
Troubleshooting
The PR3 Xtra requires a driver for Windows. If the driver is not installed or
not installed correctly the PR3 Xtra will fail to operate.
To verify proper installation of the drivers, go to the Windows Device
Manager. Under Ports (COM & LPT) there should be a Communications Port
(COMx) listed, where COMx is the communications port number or com port.
Right clicking on the communications port and then clicking on Properties
should show Digitrax, Inc. as the Manufacturer.
The COMx port number must be entered into the Soundloader, DigiIPL,
DigiMon, and DigiGroupSetup programs for proper PR3 Xtra operation.
The USB cable should always be plugged into the same USB port on the com-
puter to avoid having to change com port number in the programs. Note: If the
USB cable is plugged into a different USB port, the COM Port WILL change.
Some other Troubleshooting steps to take:
When operating the PR3 in Stand Alone Programming Mode, make sure the
PS14 is plugged in.
Try swapping the USB cable with another known good USB cable.
Reset the PR3 to Factory Default Setting.
©2013 Digitrax, Inc.
Complete Train Control
Run Your Trains, Not Your Track!
www.digitrax.com
6