Digitrax DSXSV9 Instrucciones

Navegue en línea o descargue pdf Instrucciones para Sistemas de control Digitrax DSXSV9. Digitrax DSXSV9 2 páginas. 9g turnout or motion control servo, with mount bracket and installation hardware

Imprimir página

DSXSV9

Features:

▪

Mini 9G servo for turnout control, compatible with Digitrax DS78V decoder.

▪

Includes compact under layout mount bracket, allowing ~1.8" mount depth.

▪

Includes both 0.6mm and 0.8mm z-bend formed actuator drive-wires.

▪

Adjustable; slew range with horn arm holes, and angle offset on shaft spline.

▪

Includes 5/16" mount screws, actuator horns and servo hardware.

Parts List

1 DSXSV9 9G servo

1 Instruction Sheet

1.0 Servo Mount Assembly

Place the DSXSV9 servo without horn arm on the rear side of the mount

bracket with the wires away from the mount top, as shown in figure 1 . Use

two larger head 1/4" long screws from horn arm hardware bag to attach

servo to mount.

Drive the DSXSV9 to its center

position by e.g. plugging into a

powered DS78V in Adjustment

mode centering state. See DS78V

manual section 2.0.

Poke through the z-bend end of

e.g. thin 0.6mm drive-wire into

the outer hole of the short horn

arm, then place the wire free tip

through the center pivot hole in

the plastic mount base, as shown

in figure 1.

To mechanically center; align

horn arm end pointing at the ser-

vo cable on the centerline, then

gently press horn center onto

the servo shaft spline. Use the

DS78V to then confirm that the

DSXSV9 now has almost sym-

metric Thrown (clockwise or CW)

and Closed (CCW) angles from

centerline. In e.g. the Thrown

position shown, use the small 5/32" long screw to lock the horn arm center

down to the shaft with this approximate mechanical center position.

Drive the servo back to centered position, so it is aligned and can be un-

plugged and later installed on the layout with drive-wire centered under the

turnout throw-bar drive hole, with aid of the base-template. Do not drive the

horn arm manually, as this will damage gears. For dry indoor use only.

Complete Train Control

Run Your Trains, Not Your Track!

9G Turnout or motion control servo, with

mount bracket and installation hardware

2 z-bend actuator drive-wire sizes

1 9G Mount, screws and horn arm pack

— 1 —

Mount top: face

center pivot hole

towards layout

underside. 4

mount slots to

align/attach.

Digitrax

9G mount

bracket

front

Clamp holes

for optional

remote actu-

ator cables

z-bend

through

outer arm

hole

servo cable, on centerline

drive-wire, up

to throw-bar

drive hole

upper

1/4" servo

mount

screw tip

9G servo

body, insert

from mount

rear side

short horn

arm: shown

in servo

Thrown/CW

position

horn arm

retain screw

Figure 1.