Cisco RSP7000 Instalación de - Página 8

Navegue en línea o descargue pdf Instalación de para Hardware de red Cisco RSP7000. Cisco RSP7000 26 páginas. Upgrade kit in the cisco 7000 series routers
También para Cisco RSP7000: Manual de instalación y configuración (48 páginas)

Imprimir página

Installation Prerequisites

Flash Memory Card Replacement and Formatting Prerequisites

If you have a Flash memory card installed in the PCMCIA slot of your RP, you must reformat it if

you want to use it with your new RSP7000. Using the RSP7000, you cannot read data on the RP's

Flash memory card, nor can you use it as bootable media. You must reformat the RP's Flash card

before you can use it with the RSP7000. Flash memory cards formatted on the RP-based systems

(7000 series routers) are formatted differently from Flash memory cards formatted on RSP-based

systems (7500 series routers).

Caution

loss of important data that might be stored on a Flash memory card, proceed carefully. If you want

to save the data on a Flash memory card, copy the data to a server before you format the card.

Note

section "Downloading (Retrieving) the Conﬁguration File," on page 14.

Overview of Processor Module Replacement

When you remove or install a processor module, be sure to use the ejector levers, which help to

ensure that the processor module is fully inserted in the backplane or fully dislodged from it. Any

processor module that is only partially connected to the backplane can halt the system.

Figure 5 on page 9 shows a detail of the ejector lever mechanism in a vertical position that is

appropriate for the Cisco 7000. The processor module slots in the Cisco 7010 are oriented

horizontally. When you simultaneously push the ejector levers inward (toward the carrier handle),

the levers push the processor into the slot and ensure that the board connectors are fully seated in the

backplane.

In the Cisco 7000, the RSP7000 must be installed in the 7000 RSP slot (slot 5) and the RSP7000CI

must be installed in the 7000 CI slot (slot 6). In the Cisco 7010, the RSP7000 must be installed in

the 7000 RSP slot (slot 3) and the RSP7000CI must be installed in the 7000 CI slot (slot 4).

8 Installing the RSP7000 Upgrade Kit in the Cisco 7000 Series Routers

The formatting procedure erases all information on the Flash memory card. To prevent the

Refer to the section "Uploading (Copying) the Conﬁguration File," on page 12, and then the