Cisco TelePresence Server 7010 Manual de instrucciones de sustitución - Página 17

Navegue en línea o descargue pdf Manual de instrucciones de sustitución para Hardware de red Cisco TelePresence Server 7010. Cisco TelePresence Server 7010 23 páginas. 600w ac-input power supply and fan tray replacement
También para Cisco TelePresence Server 7010: Manual de instrucciones de instalación (15 páginas), Manual de instalación (14 páginas), Primeros pasos (16 páginas), Manual de instrucciones de sustitución (18 páginas)

Using the thumb and foreﬁnger of each hand to pinch each ejector, simultaneously push

Step 9

both ejectors inward (toward the carrier handle) until they snap into place and are at a full

90-degree orientation to the faceplate. (See Figure 8c.) The carrier ears (the ends of the

faceplate) should be ﬂush against the chassis.

Step 10

Use a screwdriver to tighten the two captive screws to prevent the processor module from

becoming partially dislodged from the backplane and to ensure proper EMI shielding.

Repeat Steps 2 through 10 for the remaining interface processors.

Step 11

Repeat Steps 3 through 10 for the SP (or SSP) and RP in the Cisco 7010, and the RSP1 in

Step 12

the Cisco 7505.

Figure 9

Handling a Processor Module

Captive installation

screws

Note

Leave the interface processor ﬁller installed in any unﬁlled interface processor slots.

This completes the processor module removal and replacement procedure. If you now need to install

the new chassis in an equipment rack, proceed to the section "Installing the New Chassis in the

Rack" on page 10. Otherwise, proceed to the next section to check the installation.

Cisco 7010 and Cisco 7505 Chassis Replacement Instructions

Replacing the Chassis