Cisco TelePresence Server 7010 교체 지침 매뉴얼 - 페이지 17
{카테고리_이름} Cisco TelePresence Server 7010에 대한 교체 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence Server 7010 23 페이지. 600w ac-input power supply and fan tray replacement
Cisco TelePresence Server 7010에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (15 페이지), 설치 매뉴얼 (14 페이지), 시작하기 (16 페이지), 교체 지침 매뉴얼 (18 페이지)
페이지 인쇄
Using the thumb and forefinger of each hand to pinch each ejector, simultaneously push
Step 9
both ejectors inward (toward the carrier handle) until they snap into place and are at a full
90-degree orientation to the faceplate. (See Figure 8c.) The carrier ears (the ends of the
faceplate) should be flush against the chassis.
Step 10
Use a screwdriver to tighten the two captive screws to prevent the processor module from
becoming partially dislodged from the backplane and to ensure proper EMI shielding.
Repeat Steps 2 through 10 for the remaining interface processors.
Step 11
Repeat Steps 3 through 10 for the SP (or SSP) and RP in the Cisco 7010, and the RSP1 in
Step 12
the Cisco 7505.
Figure 9
Handling a Processor Module
Captive installation
screws
Note
Leave the interface processor filler installed in any unfilled interface processor slots.
This completes the processor module removal and replacement procedure. If you now need to install
the new chassis in an equipment rack, proceed to the section "Installing the New Chassis in the
Rack" on page 10. Otherwise, proceed to the next section to check the installation.
Cisco 7010 and Cisco 7505 Chassis Replacement Instructions
Replacing the Chassis
17