Cisco Universal Broadband Router Cisco uBR10012 Manual - Página 22

Navegue en línea o descargue pdf Manual para Hardware de red Cisco Universal Broadband Router Cisco uBR10012. Cisco Universal Broadband Router Cisco uBR10012 28 páginas. Ac power entry module for the universal broadband router
También para Cisco Universal Broadband Router Cisco uBR10012: Manual de consulta rápida (38 páginas)

Imprimir página

Cisco Universal Broadband Router Cisco uBR10012 Manual

Removing and Replacing an AC PEM

Figure 12

CIS CO

100 00

AL AR MS

Position the second replacement AC PEM in the power bay and push it forward. Verify that it goes all

Step 8

the way in and makes a secure connection with the backplane. Tighten the captive screws to secure the

unit to the chassis

Although one AC PEM can supply sufficient power for a fully configured chassis, run the

Caution

Cisco uBR10012 router with two AC PEMs installed, because this provides redundant power support.

Step 9

Plug the AC-input power cable into the power receptacle on the front panel of each AC PEM.

Step 10

Route the power cable up the front of the AC PEM and clip it into the two plastic retaining clips attached

to the surface of the PEM. Route the power cable out through the right side, so that it fits through the

notch on the right side of the front bezel cover.

AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router

Installing the AC PEM

P O W E R

CIS CO

F A U L T

100 00

P O W E R

F A U L T

(Figure

12).

(Figure

13)

OL-24536-01