Cisco 2500 Series Manual de implantación - Página 5
Navegue en línea o descargue pdf Manual de implantación para Servidor Cisco 2500 Series. Cisco 2500 Series 23 páginas. Wireless controller
También para Cisco 2500 Series: Manual de instalación (12 páginas), Manual de configuración (19 páginas), Manual de configuración (50 páginas), Manual de introducción (47 páginas)
Imprimir página
Configure the Neighbor Switch
By default, all four ports on the Cisco 2500 Series Wireless Controller are 802.1Q trunk ports. The controller
is always connected to a Gigabit Ethernet port on the neighboring switch. The neighbor switch port is
configured as an 802.1Q trunk and only the appropriate VLANs are allowed on the trunk. All other VLANs
are pruned. This is not necessary, but is a deployment best practice because by pruning irrelevant VLANs, the
controller only processes relevant frames, optimizing performance.
This is the 802.1Q switchport configuration:
switchport
switchport trunk encapsulation dot1q
switchport trunk native vlan X
switchport trunk allowed vlan X
switchport mode trunk
end
Configure the Cisco 2500 Series Wireless Controller
Configure the Controller Using the Startup Wizard
(Cisco Controller)
Welcome to the Cisco Wizard Configuration Tool
Use the '−' character to backup
Would you like to terminate autoinstall? [yes]: yes
AUTO−INSTALL: process terminated −− no configuration loaded
System Name [Cisco_d9:24:44] (31 characters max): Szabla
Enter Administrative User Name (24 characters max): cisco
Enter Administrative Password (3 to 24 characters): ********
Re−enter Administrative Password
Management Interface IP Address: 10.10.10.20
Management Interface Netmask: 255.255.255.0
Management Interface Default Router: 10.10.10.1
Management Interface VLAN Identifier (0 = untagged): 0
Management Interface Port Num [1 to 4]: 1
Management Interface DHCP Server IP Address: 10.10.10.1
Virtual Gateway IP Address: 1.1.1.1
Mobility/RF Group Name: Jmobile
Network Name (SSID): Szabla
Configure DHCP Bridging Mode [yes][NO]: no
Allow Static IP Addresses [YES][no]: no
Configure a RADIUS Server now? [YES][no]: no
Warning! The default WLAN security policy requires a RADIUS server.
Please see documentation for more details.
Enter Country Code list (enter 'help' for a list of countries) [US]: US
Enable 802.11b Network [YES][no]: yes
Enable 802.11a Network [YES][no]: yes
Enable 802.11g Network [YES][no]: yes
Enable Auto−RF [YES][no]: yes
Configure a NTP server now? [YES][no]: no
Configure the system time now? [YES][no]: yes
Enter the date in MM/DD/YY format: 04/14/11
Enter the time in HH:MM:SS format: 15:52:20
Configuration correct? If yes, system will save it and reset. [yes][NO]: yes
: ********