Cisco Nexus 7000 Series Manual de instalación - Página 3

Navegue en línea o descargue pdf Manual de instalación para Servidor Cisco Nexus 7000 Series. Cisco Nexus 7000 Series 16 páginas. Switch chassis
También para Cisco Nexus 7000 Series: Manual de referencia (2 páginas), Manual de instrucciones de instalación (39 páginas), Referencia (34 páginas), Manual de instalación (18 páginas), Configuración de (8 páginas), Manual de configuración (28 páginas), Manual de inicio rápido (10 páginas), Manual de inicio rápido (29 páginas), Manual de instrucciones de sustitución (14 páginas), Manual de instrucciones de sustitución (21 páginas), Manual de solución de problemas (10 páginas)

Installing the Switch Chassis

• Air filter kit — Optional

• Air filter (1) for the front door

• Cable-management frame brush filters (2)

• M3 x 12 mm flat-head Phillips screws (4)

• Center-mount kit — For Two-Post rack installation

Step 2

Check the contents of each box for damage.

Step 3

If you notice any discrepancies or damage, send the following information to your customer service representative by

email:

• Invoice number of the shipper (see the packing slip)

• Model and serial number of the missing or damaged unit

• Description of the problem and how it affects the installation

Installing the Chassis in a Two-Post Rack

Before you begin

• Verify that the chassis shipment is complete and undamaged.

• Verify that a two-post rack is installed and secured to the subfloor.

•

• If there are other devices in the rack, verify that the devices that are heavier than this chassis are installed

• Verify that the data center ground is accessible where you are installing the chassis.

Note

Fully loaded, the chassis can weigh up to 81.7 lb (37.05 kg). You can lighten the chassis for easier moving

by removing a power supply. To determine the full weight of the chassis and the appropriate weight rating

for the mechanical lift, see

Warning

Stability hazard. The rack stabilizing mechanism must be in place, or the rack

must be bolted to the floor before you slide the unit out for servicing. Failure to

stabilize the rack can cause the rack to tip over.

below where you are going to install the chassis and lighter devices are installed above where you are

going to install the chassis.

Weights and Quantities for the Chassis, Modules, Fan Trays, and Power

Installing the Chassis in a Two-Post Rack

Installing the Switch Chassis

Supplies.