Epson ES-300C Boletín de asistencia sobre productos - Página 6

Navegue en línea o descargue pdf Boletín de asistencia sobre productos para Escáner Epson ES-300C. Epson ES-300C 13 páginas. Laser & non-impact printer error codes
También para Epson ES-300C: Boletín de asistencia sobre productos (19 páginas), Manual (8 páginas), Manual complementario (15 páginas), Manual (11 páginas), Boletín de asistencia sobre productos (20 páginas), Boletín de asistencia sobre productos (14 páginas), Boletín de asistencia sobre productos (25 páginas)

Imprimir página
Epson ES-300C Boletín de asistencia sobre productos
[S] PROCESSING
The printer is processing data.
[S] QUIT THE JOB
The On-Line button has been pressed while a print job was in progress.
job can be flushed by pressing the Reset button, or a reset can be cancelled
by pressing any other button.
[S] QUITTING THE JOB
The printer is flushing a job from the buffer.
[S] READY
The printer is ready to receive data.
[S] RESETTING
This message appears initially when the printer is turned on, and
momentarily between print jobs.
[E] TONER LOW
The imaging cartridge must be replaced.
[S] WAIT FOR READY
The On-Line button was pressed while a print job was in progress.
printer continues printing until the current job is completed, then it goes
Off-line.
[S] WAITING
The printer is in the process of executing a job and has run out of data and
is waiting for the channel to provide more data.
EPL-7000 cont.
[S] WARMING UP
The printer is warming up.
Note:
If any of the following messages appear, turn the printer off for at
least five seconds, then turn it back on.
displayed, repair is required.
SCAN MOTOR ERROR
HSYNC ERROR
HEATER LAMP ERROR
MAIN MOTOR ERROR
FAN MOTOR ERROR
------------------------------------------------------------------------------
ES300C Display Codes
E-C
Command error.
E-1
Interface error
a. Incorrect communication parameter received.
b. Broken connector or wire.
c. Host failed to respond within 30 seconds.
d. Host is not accepting data. (DSR=Low)
E-F
Fatal error
a. A lamp is broken.
b. Power is applied before the transportation screws were removed.
c. System failure
------------------------------------------------------------------------------
An unidentified command or parameter was detected.
If the same message is
The
The