- ページ 6
スキャナー Epson ES-300CのPDF 製品サポート速報をオンラインで閲覧またはダウンロードできます。Epson ES-300C 13 ページ。 Laser & non-impact printer error codes
Epson ES-300C にも： 製品サポート速報 (19 ページ), マニュアル (8 ページ), 補足マニュアル (15 ページ), マニュアル (11 ページ), 製品サポート速報 (20 ページ), 製品サポート速報 (14 ページ), 製品サポート速報 (25 ページ)
ページを印刷する
[S] PROCESSING
The printer is processing data.
[S] QUIT THE JOB
The On-Line button has been pressed while a print job was in progress.
job can be flushed by pressing the Reset button, or a reset can be cancelled
by pressing any other button.
[S] QUITTING THE JOB
The printer is flushing a job from the buffer.
[S] READY
The printer is ready to receive data.
[S] RESETTING
This message appears initially when the printer is turned on, and
momentarily between print jobs.
[E] TONER LOW
The imaging cartridge must be replaced.
[S] WAIT FOR READY
The On-Line button was pressed while a print job was in progress.
printer continues printing until the current job is completed, then it goes
Off-line.
[S] WAITING
The printer is in the process of executing a job and has run out of data and
is waiting for the channel to provide more data.
EPL-7000 cont.
[S] WARMING UP
The printer is warming up.
Note:
If any of the following messages appear, turn the printer off for at
least five seconds, then turn it back on.
displayed, repair is required.
SCAN MOTOR ERROR
HSYNC ERROR
HEATER LAMP ERROR
MAIN MOTOR ERROR
FAN MOTOR ERROR
------------------------------------------------------------------------------
ES300C Display Codes
E-C
Command error.
E-1
Interface error
a. Incorrect communication parameter received.
b. Broken connector or wire.
c. Host failed to respond within 30 seconds.
d. Host is not accepting data. (DSR=Low)
E-F
Fatal error
a. A lamp is broken.
b. Power is applied before the transportation screws were removed.
c. System failure
------------------------------------------------------------------------------
An unidentified command or parameter was detected.
If the same message is
The
The