Cisco UCS B460 M4 Nota de instalación y mantenimiento - Página 17

Navegue en línea o descargue pdf Nota de instalación y mantenimiento para Servidor Cisco UCS B460 M4. Cisco UCS B460 M4 46 páginas. Blade server
También para Cisco UCS B460 M4: Ficha de datos (7 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (5 páginas), Nota de instalación y mantenimiento (50 páginas)

Installing a Blade Server

This chapter contains the following sections:

•

If a UCS B460 M4 blade server is mixed with other full-width or half-width blades in the chassis, the UCS

B460 M4 blade servers must occupy the bottom two full-width slots in the chassis. The chassis should be

loaded with the largest server on the bottom, starting with a UCS B460 M4 blade server on the bottom,

followed by full-width blades above, and the half-width blades at the very top of the chassis.

Procedure

Step 1

If necessary, remove the slot divider from the chassis.

a) Simultaneously pull up on the left side catch and push down on the right side catch as shown in callout 1

of the following figure.

Installing a Blade Server in the Chassis, page 9

Server Configuration, page 11

Powering Off a Blade Server, page 12

Removing a Blade Server from the Chassis, page 12

Server Troubleshooting, page 13

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs

C H A P T E R