Cisco UCS B460 M4 Note d'installation et d'entretien - Page 17

Parcourez en ligne ou téléchargez le pdf Note d'installation et d'entretien pour {nom_de_la_catégorie} Cisco UCS B460 M4. Cisco UCS B460 M4 46 pages. Blade server
Également pour Cisco UCS B460 M4 : Fiche technique (7 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (5 pages), Note d'installation et d'entretien (50 pages)

Installing a Blade Server

This chapter contains the following sections:

•

If a UCS B460 M4 blade server is mixed with other full-width or half-width blades in the chassis, the UCS

B460 M4 blade servers must occupy the bottom two full-width slots in the chassis. The chassis should be

loaded with the largest server on the bottom, starting with a UCS B460 M4 blade server on the bottom,

followed by full-width blades above, and the half-width blades at the very top of the chassis.

Procedure

Step 1

If necessary, remove the slot divider from the chassis.

a) Simultaneously pull up on the left side catch and push down on the right side catch as shown in callout 1

of the following figure.

Installing a Blade Server in the Chassis, page 9

Server Configuration, page 11

Powering Off a Blade Server, page 12

Removing a Blade Server from the Chassis, page 12

Server Troubleshooting, page 13

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs

C H A P T E R