Acuity Brands CPANL DCMK 224 Manual de instrucciones de instalación - Página 6
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Bastidores y soportes Acuity Brands CPANL DCMK 224. Acuity Brands CPANL DCMK 224 17 páginas. Surface mount kit
Imprimir página
6
Mount CPANL to hanger brackets –
Safely climb to height where you can see receiving tabs of hanger side brackets.
Start by locating hinge points on CPANL, position panel so you are holding it with the hinges away from you, see Figure 6A.
Then bring hinge side of panel up to receiving tabs on hanger brackets.
Insert both receiving tabs through the slots in the hinge brackets.
Slide the hinge brackets up to, and then past, the locking springs, see Figure 6B.
There will be a click as the hinge bracket goes past the locking spring, this will prevent hinge from sliding off tabs.
Finally, gently push CPANL toward hinges to full seat in back of bracket and rotate latch side of fixture up towards ceiling until you are able
to clip tether cables (2x) into place on the front of hanger bracket, see Figure 6C.
Receiving
Tabs
Hinge Brackets
Figure 6A
7
Make electrical connections in junction box -
Wire nuts included with CPANL.
Make all electrical connections according to local code.
All wires must be connected as indicated below for proper installation:
-- Required input wires (Qty 3) on CPANL:
1) GREEN / YELLOW wire – Ground
2) WHITE wire - Neutral Line-In
3) BLACK wire - Hot Line-In
-- Optional dimming wires (Qty 2):
4) PURPLE wire - 0-10V (+) (must be capped-off if not used)
5) GRAY/PINK wire - 0-10V (-) (must be capped-off if not used)
12/8/2020 Rev C
CPANL SURFACE MOUNT KIT - INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION DE CPANL KIT DE MONTAGE EN SURFACE
INSTRUCCIONES DE INSTALACIÓN DE CPANL KIT DE MONTAJE EN SUPERFICIES
Figure 6C
1
Figure 6B
Lock
Figure 7
Page 5 of 16
2