Acuity Brands CPANL DCMK 224 Handleiding voor installatie-instructies - Pagina 6

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Acuity Brands CPANL DCMK 224. Acuity Brands CPANL DCMK 224 17 pagina's. Surface mount kit

Pagina afdrukken

Acuity Brands CPANL DCMK 224 Handleiding voor installatie-instructies

Mount CPANL to hanger brackets –

 Safely climb to height where you can see receiving tabs of hanger side brackets.

 Start by locating hinge points on CPANL, position panel so you are holding it with the hinges away from you, see Figure 6A.

 Then bring hinge side of panel up to receiving tabs on hanger brackets.

 Insert both receiving tabs through the slots in the hinge brackets.

 Slide the hinge brackets up to, and then past, the locking springs, see Figure 6B.

 There will be a click as the hinge bracket goes past the locking spring, this will prevent hinge from sliding off tabs.

 Finally, gently push CPANL toward hinges to full seat in back of bracket and rotate latch side of fixture up towards ceiling until you are able

to clip tether cables (2x) into place on the front of hanger bracket, see Figure 6C.

Receiving

Tabs

Hinge Brackets

Figure 6A

Make electrical connections in junction box -

 Wire nuts included with CPANL.

 Make all electrical connections according to local code.

 All wires must be connected as indicated below for proper installation:

-- Required input wires (Qty 3) on CPANL:

1) GREEN / YELLOW wire – Ground

2) WHITE wire - Neutral Line-In

3) BLACK wire - Hot Line-In

-- Optional dimming wires (Qty 2):

4) PURPLE wire - 0-10V (+) (must be capped-off if not used)

5) GRAY/PINK wire - 0-10V (-) (must be capped-off if not used)

12/8/2020 Rev C

CPANL SURFACE MOUNT KIT - INSTALLATION INSTRUCTIONS

INSTRUCTIONS D'INSTALLATION DE CPANL KIT DE MONTAGE EN SURFACE

INSTRUCCIONES DE INSTALACIÓN DE CPANL KIT DE MONTAJE EN SUPERFICIES

Figure 6C

Figure 6B

Lock

Figure 7

Page 5 of 16