Acuity Controls ECLYPSE A1000 Manual de instalación - Página 9
Navegue en línea o descargue pdf Manual de instalación para Controlador Acuity Controls ECLYPSE A1000. Acuity Controls ECLYPSE A1000 10 páginas. Asset tracking
También para Acuity Controls ECLYPSE A1000: Manual de instalación (14 páginas)
Imprimir página
6.0 - Additional Information
6.3 North American Emissions Compliance
United States
Changes or modifications not expressly approved by
Acuity could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential and commercial installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
7.0 - Sub-gigahertz Assets Adapter Mounting
Instructions
7.1 Typical Mounting Scenarios
The Sub-gigahertz Assets Adapter is typically mounted
in one of three common scenarios, these include:
•
Suspended Ceiling Mount
•
Mounting Bracket
•
Metal Panel/Utility Box
Whichever mounting scenario is chosen, the Assets
Adapter should be 16" (41 cm) or more away from any
network communication devices and not too close to the
actual ECLYPSE A1000AT. The Assets Adapter
connects directly to the ECLYPSE via the USB port. You
are supplied with a 16' cable. This cable cannot be made
any longer and must not be modified.
Acuity Brands | One Lithonia Way Conyers, GA 30012 Phone: 800.535.2465 www.acuitycontrols.com © 2017-2019 Acuity Brands Lighting, Inc. All rights reserved. 03/29/19
Canada
This Class (B) digital apparatus meets all the require-
ments of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la Classe (B) respecte toutes
les exigences du Règlement sur le matériel brouilleur du
Canada.
7.2 Instructions for Ceiling Mount
1. Use .875" (22mm) hole saw to create a mounting
hole position.
2. Disassemble the Assets Adapter: Unbox the
adapter, remove nut from the adapter, make sure
the gasket is on the adapter.
3. Place device in ceiling panel, place nut onto the USB
cable and hand tighten nut to the ceiling panel.
4. Connect the USB cable assembly's USB jack to one
of the controller's Host USB ports.
See Figure 14 on the following page for illustration.
A1000AT_IG_10_EN
9 of 10