Epson 755c - PowerLite XGA LCD Projector Manual de piezas - Página 24

Imprimir página

Epson 755c - PowerLite XGA LCD Projector Manual de piezas

Epson PowerLite 755c/765c Projector

4. Loosen the two screws holding the lamp in place (you don't

need to remove them).

5. Hold the lamp as shown and pull it straight out.

Caution:

Do not touch the glass portion of the lamp assembly. Touching

the glass could result in premature lamp failure.

6. Gently insert the new lamp. (If it doesn't fit easily, make sure

it is facing the right way.)

Note:

The lamp(s) in this product contain mercury. Please consult

your state and local regulations regarding proper disposal or

recycling. Do not place in the trash.

7. Once the lamp is fully inserted, tighten its screws.

8. Insert the two cover tabs, then press down on the cover until

it snaps into place.

9. Reset the lamp timer as described in the next section.

Epson PowerLite 755c/765c Projector

Resetting the Lamp Timer

You must reset the lamp timer after replacing the lamp to clear

the

Replace the Lamp

Note:

Do not reset the lamp timer if you have not replaced the lamp. If

you do, the

Lamp Hours

hours that the lamp has been used.

1. Connect the power cable and turn on the projector.

2. Press the

button on the remote control and select the

menu. Then press

Reset

3. Select

Lamp-Hours Reset

prompt:

4. Select

and press

Yes

5. Press

to return to the Reset menu or the

Esc

to exit the menu system.

8/05

message.

will not accurately reflect the number of

. You see this screen:

Enter

and press

. You see this

Enter

button