Epson 755c - PowerLite XGA LCD Projector Parts Manual - Page 24

Browse online or download pdf Parts Manual for Software Epson 755c - PowerLite XGA LCD Projector. Epson 755c - PowerLite XGA LCD Projector 26 pages. Release of check tool for network projectors v1.00 for windows
Also for Epson 755c - PowerLite XGA LCD Projector: User Manual (42 pages), Operation Manual (36 pages), Specification Sheet (2 pages), Operation Manual (47 pages), Product Support Bulletin (30 pages), User Replaceable Items (1 pages), Quick Setup (2 pages), Installation Manual (19 pages), User Manual (1 pages), Function Manual (5 pages), Product Support Bulletin (25 pages), Product Support Bulletin (38 pages), Product Support Bulletin (12 pages), Product Support Bulletin (42 pages), Product Support Bulletin (22 pages), Product Support Bulletin (28 pages), Product Support Bulletin (41 pages), Product Support Bulletin (34 pages), Product Support Bulletin (38 pages), Product Support Bulletin (28 pages), Product Support Bulletin (15 pages), Product Support Bulletin (22 pages)

Print Page

Epson 755c - PowerLite XGA LCD Projector Parts Manual

Epson PowerLite 755c/765c Projector

4. Loosen the two screws holding the lamp in place (you don't

need to remove them).

5. Hold the lamp as shown and pull it straight out.

Caution:

Do not touch the glass portion of the lamp assembly. Touching

the glass could result in premature lamp failure.

6. Gently insert the new lamp. (If it doesn't fit easily, make sure

it is facing the right way.)

Note:

The lamp(s) in this product contain mercury. Please consult

your state and local regulations regarding proper disposal or

recycling. Do not place in the trash.

7. Once the lamp is fully inserted, tighten its screws.

8. Insert the two cover tabs, then press down on the cover until

it snaps into place.

9. Reset the lamp timer as described in the next section.

Epson PowerLite 755c/765c Projector

Resetting the Lamp Timer

You must reset the lamp timer after replacing the lamp to clear

the

Replace the Lamp

Note:

Do not reset the lamp timer if you have not replaced the lamp. If

you do, the

Lamp Hours

hours that the lamp has been used.

1. Connect the power cable and turn on the projector.

2. Press the

button on the remote control and select the

menu. Then press

Reset

3. Select

Lamp-Hours Reset

prompt:

4. Select

and press

Yes

5. Press

to return to the Reset menu or the

Esc

to exit the menu system.

8/05

message.

will not accurately reflect the number of

. You see this screen:

Enter

and press

. You see this

Enter

button