Epson 7850p - PowerLite XGA LCD Projector Manual de información del producto - Página 15

Imprimir página

Epson 7850p - PowerLite XGA LCD Projector Manual de información del producto

EPSON PowerLite 7850p Projector

3. Click the

button. Then click the

Configure

on the screen that appears. You see a screen like this:

4. Ad Hoc mode: Highlight

list and set the Value to

Access Point mode: Highlight

Value to

Infrastructure

5. Ad Hoc mode: Highlight

the name you gave the projector's ESSID (for example,

). If your network card uses channel mode

CONF ROOM

instead, set the correct channel, 1 to 11, to match that of

the projector.

Access Point mode: Highlight

match the name assigned to the access point.

6. Highlight

Encryption

7. Click the

tab and make sure the network card or

General

wireless network device is enabled.

8. Ad Hoc mode: Click

properties dialog box. Then go to "Projecting Wirelessly"

on page 15.

Access Point mode: On the General tab, select

, then click the

Protocol

screen:

EPSON PowerLite 7850p Projector

Advanced

in the Property

Network Type

802.11 Ad Hoc

and set the

Network Type

and set the Value to match

SSID

and set the Value to

SSID

and make sure it is disabled.

to close the network card's

Internet

button. You see this

Properties

tab

9. If your access point uses DHCP, select

automatically

and enter the required information.

address

❏

IP address

to the computer. It must be formatted like other

addresses on the network; usually the first three

segments (XXX.XXX.XXX) match the access point's IP

address.

❏

Subnet mask

this too must match how your network was set up.

❏

Default gateway

assigned to the access point when it was set up.

10. When done, click

11. Click the

Wireless Networks

Note: If you don't see this tab, you may need to enable your

wireless card or network device by clicking

access the device settings; then follow any instructions on the

screen to enable the device.

6/03

Obtain IP address

. Otherwise, select

Use the following IP

: Type in the IP address you want to assign

: For example, 255.255.255.000, but

: Enter the IP address that was

tab. You see this screen:

Configure