Epson Stylus Pro 10000 Series Manual de montaje - Página 8

Navegue en línea o descargue pdf Manual de montaje para Software Epson Stylus Pro 10000 Series. Epson Stylus Pro 10000 Series 12 páginas. Auto take-up reel unit
También para Epson Stylus Pro 10000 Series: Especificaciones (6 páginas), Información sobre el producto (16 páginas), Manual de instalación (26 páginas), Manual de instalación rápida (34 páginas), Manual de consulta rápida (12 páginas), Garantía (28 páginas), Manual de consulta rápida (12 páginas), Especificaciones (4 páginas), Especificaciones (1 páginas), Manual del usuario (13 páginas)

2. Lock the two casters (A) and extend the two

stabilizer knobs (B) underneath the base unit.

3. Lift the printer unit by the eight hand grips

shown below. Then insert the printer unit into

the guide pins on the base unit.

Caution:

Do not attempt to lift the printer unit with

fewer than four people.

Note:

When you place the printer on the base unit, match

the right end square of the printer (shown as 4 inthe

illustration below) to the square of the same part of

the base unit.

4. Screw the two wing nuts (C) into the left and

5. Release the front casters and the stabilizer

6. Remove the protective materials:

7. Close the lower cover.

top view

right joint holes at the side-inner of the base

unit, and tighten them.

knobs and move the printer to the place of use

(a short distance away). Lock the casters and

extend the stabilizer knobs after moving.

from the lower cover (tapes).

from the platen (tapes).

from the side of the print head compartment

(fixing metal plate inside the lower cover).

Caution:

Watch your fingers when opening and

closing the lower cover.